Menü überspringen

POSITIP 880

Request

Documentation

undefinedBrochure
undefinedManuals

POSITIP 880

Axes

Up to 6 axes from A to Z and ZO, ZS

Encoder inputs

6 x 1 VPP, 11 µAPP or EnDat 2.1; D-sub female 15-pin (automatic interface recognition)

Input frequency

≤ 100 kHz

Signal period

0.128 µm, 2 µm, 4 µm, 10 µm, 20 µm, 40 µm, 100 µm, 10 240 µm, 12 800 µm

Line count

Any

Subdivision factor

Max. 1024-fold

Display step 1)

Linear axis: 1 mm to 0.005 µm

Angular axis: 0.01° to 0.000 1° (00° 00‘ 01‘‘)

Display

Color flat screen for position values, dialog and input displays, graphic functions, graphic positioning support and contour monitoring

Status display

Operating mode, REF, reference-point number, tool number, inch, scale, feed-rate display, stopwatch

For milling/drilling/boring

Tool compensation R+, R–

For turning

Radius/diameter display; separate or sum display for Z and ZO

Functions

  • REF reference-mark evaluation for distance-coded or single reference marks
  • Distance-to-go mode, nominal position input (absolute or incremental)
  • Scaling factor
  • Contour monitoring with magnify function
  • Any axis combinations
  • HELP: On-screen operating instructions
  • INFO: Stopwatch, pocket calculator, cutting data calculator (for milling), taper calculator (for turning)

For milling/drilling/boring

  • 99 datums and 99 tools
  • Calculation of positions for hole patterns (circular patterns as well as linear patterns)
  • Tool radius compensation
  • Probing function for datum acquisition with the KT edge finder: "Edge," "Centerline" and "Circle center"
  • Positioning aids for milling and the roughing out of a rectangle pocket

For turning

  • 1 datum, 99 tools
  • Freezing tool position for back-off
  • Oversize allowances

Programming

Up to 999 program blocks per program; sub programming capability with turning and mirroring; teach-in programming

Cycles For milling/drilling

For turning

Line segments, circular arcs, chamfers, circular and linear hole patterns, rectangular pockets

Line segments, circular arcs, chamfers, multipass

Error compensation

Linear and multipoint, up to 128 measuring points

Interfaces Serial

Parallel

RS-232-C/V.24 300 to 115 200 baud

  • For output of programs, measured values and parameters
  • For loading of programs and parameters

Centronics for output of measured values

Switching I/O

  • Via IOB 89 external input/output unit
  • 1 input for KT edge finder

Accessories

KT edge finder (milling) tilting base, tilt/swivel mount, pivot arm

Power connection

100 V to 240 V AC (–5 % to +10 %), 48 Hz to 62 Hz; 35 W

Operating temperature

0 °C to 45 °C (storage temperature –20 °C to 70 °C)

Protection EN 60 529

IP 40, front panel IP 54

Weight

Approx. 3.2 kg

1) Depends on the signal period or line count of the connected encoder